User manual

4-2 MODEM MESSAGES
(09) CONNECT 0600
(10) CONNECT 2400
(11) CONNECT 4800
(12) CONNECT 9600
(13) CONNECT 7200
(14) CONNECT 12000
(15) CONNECT 14400
(16) CONNECT 19200
(17) CONNECT 38400
(18) CONNECT 57600
Where X1, X2, X3 or X4 is active, these messages show the interface
speed, or the speed on the line, once the data connection has been
made
(22) CONNECT
75TX/1200RX
Modem has created a V.23 link in Originate mode
(23) CONNECT
1200TX/75RX
Modem has created a V.23 link in Answer mode
(24) DELAYED hh:ss:mm Where X4 is active, this message shows dialled number is inaccessi-
ble
(32) NO MORE
DIALLING
Modem goes into “Dialling Blocked” for 2 hours. This can be caused
by a power supply failure
The following messages apply where a carrier is recognized on the telephone line and S95=2 is active.
(40) CARRIER 300
(44) CARRIER 1200/75
(45) CARRIER 75/1200
(46) CARRIER 1200
(47) CARRIER 2400
(48) CARRIER 4800
(49) CARRIER 7200
(50) CARRIER 9600
(51) CARRIER 12000
(52) CARRIER 14400
V.21 or Bell 103 carrier recognized
V.23 Backward-Channel carrier recognized
V.23 Forward-Channel carrier recognized
V.22 or Bell 212 carrier recognized
V.22bis carrier recognized
Data rate of 4800 bps recognized in V.32 or V.32bis mode
Data rate of 7200 bps recognized in V.32bis mode
Data rate of 9600 bps recognized in V.32bis or V.32 mode
Data rate of 12000 bps recognized in V.32bis mode
Data rate of 14400 bps recognized in V.32bis mode
(66) COMPRESSION
CLASS 5
Modem has set up a link with MNP 5 and compression messages are
authorised
(67) COMPRESSION
V.42bis
Modem has set up a link with V.42bis and compression messages are
authorised
(69) COMPRESSION
NONE
Modem has set up a link without
data compression and compression messages are authorised
(76) PROTOCOL
NONE
Modem has set up a link with no form of Error correction and mes-
sages covering Error correction are authorised
(77) PROTOCOL
LAPM
Modem has set up a link with V.42 Error correction
(80) PROTOCOL ALT Modem has set up a link with MNP Error correction
(81) PROTOCOL
ALT CELLULAR
Modem has set up a link with MNP 10 Error correction (specially
suitable for radio telephones)