User manual

AT COMMANDS: DATA MODEM 2-3
Extended MNP- and V.42bis-Commands
AT\A
Determining Data Block Size with MNP operation
AT\B
Sending a Break signal to the remote modem
AT\F
Display stored telephone numbers
AT\G
Modem-modem flow check (XON/XOFF)
AT\J
Adjusting computer/modem speed to the modem/modem speed
AT\K
Effects of the Break Signal
AT\L
MNP Block/Stream mode
AT\N
Switching between Direct, Normal and MNP modes
AT\S
Displaying current modem configuration on screen
AT\W
Authorise V.23 operation
AT\U
Accept an MNP connection in a Normal connection
AT\V
Information content of MNP connection messages
AT\X
Transfer XON/XOFF control characters to the remote modem
AT\Y
Switch to error-free connection from Normal connection
AT\Z
Switch to Normal connection from an error-free connection
AT%C
Controlling Error correction and Data compression
AT%E
Authorise data compression
AT%F
Dialling 75Tx/1200Rx or 1200Tx/75Rx
Other Commands
AT*C
Storing password for remote configuration
AT*E
Ending remote configuration
AT*H
Handshake speed between MNP 10 modems
AT*L
Displaying Directory for callbacks protected by password
AT*P
Storing passwords for automatic callback
AT*R
Interrogating for remote configuration
AT-K
Authorising extended MNP Class 10
V.25bis Commands
CIC
Modem goes in Answer mode on to line
CRI
Dialling command with optional identification
CRN
Dialling command
CRS
Dialling a stored dialling string
DIC
Ignore incoming call
PRI
Store programme identification
PRN
Store dialling strings
RLN
Displaying stored telephone numbers (dialling strings)