User's Manual

Numeric Code Verbose Code
64 CONNECT 28800
65 CONNECT 31200
33 CONNECT 33333
66 CONNECT 33600
34 CONNECT 37333
28 CONNECT 38400
35 CONNECT 41333
36 CONNECT 42666
37 CONNECT 44000
38 CONNECT 45333
39 CONNECT 46666
42 CONNECT 48000
43 CONNECT 49333
53 CONNECT 50666
54 CONNECT 52000
55 CONNECT 53333
56 CONNECT 54666
57 CONNECT 56000
58 CONNECT 57333
18 CONNECT 57600
31 CONNECT 115200
45 RINGBACK
See Note CONNECT (DTE data rate) / (modulation) / (error correction) / (data
compression) / TX: (DCE transmit data rate) / RX: (DCE receive data rate)
Note:
This verbose response code is used to evaluate the modem connection and is
enabled by the W3 AT command. All other ’CONNECT’ messages are used
for W0- W2 AT commands. When the modem is configured for text response
V1, the W3 verbose response codes provide information about the DTE data
rate, connection modulation, error correction protocol, data compression, and
modem-to-modem data rate. When the modem is configured for W3 and
numeric responses V0, the modem responds as if set up for W0.
3-2 MODEM MESSAGES