User's Manual

&V – View Active Configuration and Stored Profiles
This command causes the modem to display the command and S-Register
information contained in the active user profile and in one or two stored
profiles. The command &V0 displays the active profile and the stored profile 0;
&V1 displays the active profile and the stored profile 1. The information in the
active profile is stored into the user profiles with the &Wn command. &W0
stores the active profile into the stored profile 0; &W1, the stored profile 1.
&V0 Stored profile 0
&V1 Stored profile 1
Table 2 Current Modem Configuration (Example)
at&v1
ACTIVE PROFILE:
B1 E1 L2 M1 N1 T Q0 V1 W0 X4 Y0 &C1 &D2 &G0 &J0 &P0 &Q0 &S0 &U0 &Y0
%A013 %C0 %E1 %G1 \A3 \C0 \G0 \J0 \K5 \N3 \Q3 \T000 \X0 -C1 -J1 "H3 "O032
S00:000 S01:000 S02:043 S03:013 S04:010 S05:008 S06:003 S07:060 S08:002
S09:006 S10:014 S11:090 S12:050 S18:000 S25:005 S30:000 S33:000 S37:000
STORED PROFILE 1:
B1 E1 L2 M1 N1 T Q0 V1 W0 X4 Y0 &C1 &D2 &G0 &J0 &P0 &Q0 &S0 &U0
%A013 %C0 %E1 %G1 \A3 \C0 \G0 \J0 \K5 \N3 \Q3 \T000 \X0 -C1 -J1 "H3 "O032
S00:000 S02:043 S06:003 S07:060 S08:002 S09:006 S10:014
S11:090 S12:050 S18:000 S25:005 S30:000 S33:000 S37:000
TELEPHONE NUMBERS: (max 30 characters)
&Z0 =
&Z1 =
&Z2 =
&Z3 =
&W – Storing a set Profile
The &Wn command is used to store a number of values of the S Register's
current configuration profile, in the non-volatile NVRAM. You can store two
different pro-files (n = 0, 1) and load these again by using the Z command.
&Y – Selecting a Start Configuration
The &Yn command is used to determine which of the non-volatile stored
profiles (&W command) will be active when the unit is switched on. The n
parameter (n = 0, 1) is used to select the profile required (factory setting is 0).
2-12 AT COMMANDS: DATA MODEM