User's Manual

To use the modem in a Dial-Up Network, it must be added to the RAS service
-> Start – Settings – Control Panel – Network (refer to the instructions in the
Windows manual).
To uninstall, remove the entry of the card in the -> Control Panel under ->
Modems and uninstall the installation software using -> Control Panel –
Software.
Installation under Windows 2000
Unpack the driver (diskette or Internet) into a temporary folder.
After installing the card and starting your computer, the operating system will
show the message New hardware -> PCI Communication Controller (single)
and the hardware assistant will be started. Search for -> the best driver for the
device (recommended) and enter the directory into which you unpacked the
driver. Windows 2000/XP will state that it has not found a digital signature.
Continue the installation anyway by clicking on -> Yes
. Confirm the messages
from the hardware assistant using Continue
when it finds the driver. Finally the
hardware assistant will have installed the required software and can be ended
by clicking on -> Finish. The HAM card should now be available in -> Control
Panel -> Telephone and Modem Options -> Modems.
=> Now you can configure and use the modem with the communications-,
fax- and Voiceprograms.
Factory settings
To make it easier for you to use your modem, two basic settings have been
made at the factory, which are suitable for most of the connections. These
settings can be activated with the “&F” command. In the fax mode or voice
mode, the relevant software will carry out control of modem settings for you.
x For Data Transmissions select AT&F0. In this condition, the modem will
attempt to create an error-corrected connection with data compression,
depending on the capability of the remote side.
1-4 INTRODUCTION