User's Manual

Antenna
(Diversity, Antenna A or Antenna B):
These settings determine which antenna
will be used to transmit or receive.
Channel
Select the appropriate channel from the
list provided to correspond with your
network settings. All devices in the
wireless LAN must be configured to
share the same radio channel in order to
work correctly.
(There are 14 channels available, depends
on the country.)
Data Rate
Select (1, 2, 5.5, or 11Mbps or Auto)
from the pull-down list to change the
current transfer rate.
Network Type
Select the appropriate Network Type
from 802.11 AdHoc Mode (Active),
802.11 AdHoc Mode (Passive) or
Infrastructure.
In AdHoc mode, Active mode is
recommended since it can generate/pass
beacon packets automatically.
Preamble
A preamble is a signal used in wireless
environment to synchronize the
transmitting timing including
Synchronization and Start frame
delimiter. (Note: Please check the setting
of AP first.)
Auto
Select Auto for the Network adapter to
select the Preamble type automatically
depending on the Access Point Preamble
type.
Long Preamble
If in a "noisy" network environment, the
Preamble Type should be set to Long
Preamble.
Short Preamble
The Short Preamble is intended for
applications where minimum overhead and
maximum performance is desired. If in a
"noisy" network environment, the
performance would be decreased.
RTS Threshold
This value should remain at its default
setting of 2347. Should you encounter
inconsistent data flow, only minor
modifications of this value are
recommended