Operating Instructions and Installation Instructions

B-10 SB Emulation in MS-DOS/ Windows 95/98/ME
-P
xxx
MPU-401 UART interface’s base I/O address.
-d
x
SB Emulation mode. For
x,
1 is Off, 0 is On.
-w
x
Set
x
to 1 to use the Windows-assigned resource configuration.
Set
x
to 0 to use (your) user-assigned resource configuration.
An example of an SBESET command is
SBESET -A240 -I5 -D3 -w0
which corresponds to “set the SB interface’s base I/O address to 240, the IRQ line used by the
audio interface to 5, the First DMA channel used by the audio interface to 3, and use the
Windows-assigned resource configuration”.
SBEGO.EXE
Use this to confirm whether SB16 Emulation is properly installed and working.