Installation guide

Installation Guide
Creative DSL PCI 7430
RFC 2364
Page 85 of 98
3.3.4 Connector Pin-out
The Creative DSL PCI 7430 is equipped with a RJ-11 jack for connection to the
DSL data port. The center two pins, pins 3 and 4, are used for DSL data. For the
Creative DSL PCI 7430 card to make a proper DSL connection, the installed
DSL data port should also use pins 3 and 4 for data. If the DSL data port
installation uses pins 2 and 5 for data, then a wiring converter will be required. Do
not alter or remove the wiring converter if present. Consult with your DSL
service provider before attempting any wiring changes.