Installation guide

Installation Guide
Creative DSL PCI 7430
RFC 2364
Page 83 of 98
Click Run Diagnostics to run the diagnostic program that will test PC functionality and report
the status. A warning message pops up that your DSL service will be disconnected before
performing the Diagnostic test. If connected to the Internet at this time, running diagnostic will
disconnect any Dial-up sessions. Click Yes to begin the Diagnostic program or click No to exit
the diagnostic program. The Diagnostic program performs a brief hardware check and displays
the hardware status.
A dialog box similar to the one shown below provides a sample result of the diagnostic.
If your Creative DSL PCI 7430 fails the Diagnostic tests (shown below), then record the test
results and contact customer support.
ADSL Bridge - PCI I/O Test I90188 chip test è Pass
I90135 Register Test I90135 chip test è Pass
I90135 Memory Test I90135 chip test è Pass
ADSL Bridge - Loopback I90188 Fast datapath è Trial 20, Pass 20
…Interleave datapath è Trial 20, Pass 20
90135 Utopia Loopback I90135 Fast datapath è Trial 20, Pass 20
…Interleave datapath è Trial 20, Pass 20
For all loop back tests, both Trial and Pass counts need to be equal to 20 for
success.
Click Close to exit the Diagnostic program when you are finished running your DSL PCI 7430
diagnostic. Your Creative DSL PCI 7430 should reconnect to the DSL service automatically
once it is closed from these diagnostic tests.