Installation guide

Installation Guide
Creative DSL PCI 7430
RFC 2364
Page 4 of 98
7 Connect one end of the supplied RJ-11 phone cable to the RJ-11 phone jack on the Creative
DSL PCI card, and plug the other end of the phone cable to a wall phone jack where the DSL
service is enabled
8 Replace the cover of the PC chassis
9 You are now ready to begin the DSL device installation
1.3 Installation CD-ROM
Your Creative DSL PCI 7430 comes with an installation CD-ROM. Make sure you have the
installation CD-ROM with you when ready for driver installation. The device driver for your
Creative DSL PCI 7430 can be found under the folder named ‘Drivers’.
1.4 Before Installation
Please ensure the following is in place before you install your Creative Blaster DSL PCI 7430:
• Subscription to a DSL Service Provider and have your Password and Username ready.
• Obtain all the necessary network setting values, such as VPI and VCI values, from your DSL
Service Provider
• Connect your DSL PCI 7430 to a DSL service-ready phone line