Installation guide

Installation Guide
Creative DSL PCI 7430
RFC 2364
Page 24 of 98
Again, Windows NT files are needed, re-insert the Microsoft Windows NT 4.0 CD-ROM at this
point. Enter the path <CD Drive letter> and :\i386, such as D:\i386 or E:\i386 according to your
system CD-ROM drive assignment. Click Continue to proceed.
Windows will continue loading files until a ‘Service Option’ dialog box appears. To accept the
default service option settings, click Next to proceed with the installation.
Unless there are special VPI and VCI values provided by your DSL Service
Provider, you should stay with recommended installation (the default value).
To change the VPI and VCI value, refer to Appendix A: Section 3.1.1, Changing
VPI and VCI values during Installation.
During the installation process you may be asked to insert your Windows NT CD-
ROM again. Insert the Windows NT 4.0 CD-ROM into your system CD-ROM
drive and click OK. If during the file copying process a file is reported as ‘not found’
enter the path D:\i386 (or E:\i386).