Specifications

PS2000 Installation Instructions
For more information contact Hubbell Wiring Device Kellems
Toll free [phone] or www.hubbell-wiring.com
P a g e | 24
Rev. 1.0--
Rev. 4.1—12.12.13
4.0 Startup Procedure
The following set of instructions outlines the process to startup the PEP Station.
Steps:
1. Activate power to both circuits of the PEP Station.
2. The unit will begin starting up automatically. This process will look similar to the start up procedure for any PC.
After about 4-5 minutes have elapsed, verify that the screen shown below in Figure 29 is displayed.
Important: When the PEP Station is going through its initial startup, do not touch the screen or
attempt to open/close any programs or applications. It is programmed to launch the program
automatically.
3. Contact the service and technical support help desk at [phone] x114 to verify that the PEP Station is
communicating over the internet.
Important: This must be completed and a connection
verified by PEP Stations corporate office.
4. The station owner will have to complete the on-line registration,
assign site administrator(s) and configure the station via a step-
by-step set up process at www.pepstations.com before the PEP
station will become available for vehicle charging.
Figure 28
Figure 29