Specifications

PS2000 Installation Instructions
For more information contact Hubbell Wiring Device Kellems
Toll free [phone] or www.hubbell-wiring.com
P a g e | 1
Rev. 4.1--12.12.13
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
WARNING- When using electrical products, basic precautions should always be followed including the following:
Read all the instructions before using this product
This device should be supervised when used around children
Do not put fingers into the electric vehicle conductor
Do not use this product if the flexible power cord or EV cable are frayed, have broken insulation, or other signs
of damage.
Do not use the PEP Station PS2000 if the enclosure or the EV connector is broken, cracked, open or shows any
other indication of damage.
Do not operate the PEP Station PS2000 in temperatures outside the operating range of -22⁰F to 131⁰F
(-30⁰C to 55⁰C)
The wiring and concrete pedestal or wall mounting bracket must be installed by a certified electrician and must
comply with local electrical codes and ordinances.
Do not install the PEP Station PS2000 near flammable, explosive or combustible materials.
WARNING- To reduce the risk of fire or electric shock, do not remove the rear panel. No user serviceable parts are
inside. Repair should only be done by Customer Service Engineers.
RISK OF ELECTRIC SHOCK
IMPORTANT- These Installation Instructions must be strictly adhered to.
The specifications, instructions and other information in this manual are subject to revision at any time without prior
notice.