User`s guide

Setting Up Your NOMAD IIc Player 2-5
Step 6: Install NOMAD II
Driver
NOMAD IIc uses the "NOMAD II"
driver.
Skip this step if you are a Macintosh
user; installing the software as
instructed in “Step 4: Install Software”
on page 2-2, would have already
installed the drivers necessary for your
NOMAD IIc to work with your
Macintosh.
For Windows users only
Once you have connected your NOMAD IIc
player to your PC,
the dialog box similar to
Figure 2-3 appears.
1. Click the Next button.
2. Select the Search for the best driver for
your device. (Recommended) option and
click the Next button.
3. Clear the Floppy disk drives check box
and select the CD-ROM drive option.
4. Click the Next button twice in succession.
The dialog box similar to Figure 2-4
appears.
5. Click the Finish button.
Step 7: Verify Correct
Installation of NOMAD II
Driver
For Windows users
1. Click Start -> Settings -> Control Panel.
2. In the Control Panel window,
double-click the System icon.
3. In the System Properties dialog box,
click the Device Manager tab.
4. In the Device Manager tabbed page,
double-click Universal Serial Bus
controllers, and then check that Creative
NOMAD II is present as shown in Figure
2-5 below.
Figure 2-3:
Add New Hardware Wizard
dialog
box.
Figure 2-4: Installation of Creative NOMAD II
driver is completed.
Figure 2-5: Verify that Creative NOMAD II
driver is installed correctly.