Specifications

Portable Drying/Conveying Systems Chapter 7: Appendix 68 of 76
Chapter 7: Appendix
7-1 Technical Specifications
Annex B Information The following design information is provided for your
reference:
1. No modifications are allowed to this equipment that could alter the CE compliance
2. Ambient temperature: 40 degrees Celsius – Maximum (104 degrees Fahrenheit)
3. Humidity range: 50% relative humidity
4. Altitude: Sea level
5. Environment: Clean, dust-free and non-explosive
6. Radiation: None
7. Vibration: Minimal, i.e. machine mounting
8. Allowable voltage fluctuation: +/- 10%
9. Allowable frequency fluctuation: Continuous +/- 1% Intermittent +/- 2%
10. Nominal supply voltage: 460/3/60 (Verify on serial number tag)
11. Earth ground type: TN (system has one point directly earthed through a protective
conductor)
12. Power supply should include a ground connection.
13. Over-current protection is supplied in the dryer and conveying system, but additional protection
should be supplied by the user.
14. The door-mounted disconnect serves as the electrical disconnect device.
15. Dryer and conveying system is not equipped with local lighting.
16. Functional identification
17. Dryer and conveying system are equipped with a CE mark
18. Dryer and conveying system is supplied with an operating manual in the language of the
destination country.
19. Cable support may be required for power cord, depending on final installation.
20. No one is required to be in the interior of the electrical enclosure during the normal operation of
the unit. Only skilled electricians should be inside the enclosure for maintenance.
21. Doors can be opened with a screwdriver, but no keys are required.
22. Two-hand control is not required or provided.
23. All dryers and conveying equipment should be moved around and set in a place with a lift truck
or equivalent.
24. There are no frequent repetitive cycles that require manual control⎯repetitive functions are
automatic while the drying and conveying system is operating.
25. An inspection report detailing the functional test is included with the dryer and conveying
system.
26. The machine is not equipped with cable-less controls.
27. Color-coded (harmonized) power cord is sufficient for proper installation.