Specifications

Portable Drying/Conveying Systems Chapter 3: Installation 19 of 76
Chapter 3: Installation
3-1 Uncrating the Equipment
Portable Drying/Conveying Systems are shipped mounted on a skid, enclosed in a plastic
wrapper, and contained in a cardboard box.
1. Pry the crating away from the skid.
Note: Remove the nails holding the box to the skid and lift the box
off carefully; avoiding staples in the 1’ x 4’ wood supports.
Cut the steel banding.
2. Use a pry bar to remove the blocks securing the unit to the skid.
3. Lift unit from sides. Use a pry bar if necessary to carefully remove the
skid from the unit.
4. Lower slowly.
3-2 Rigging and Placing the Dryer
Take care when rigging and placing the drying and conveying system. Figure 8 below shows
a suggested safe rigging diagram. It lets you lift the dryer/hopper unit vertically using a fork
truck.
Caution! Use caution and observe safety rules when lifting and placing your dryer!
Figure 8: Suggested Lift Rigging for Cart Mounted Dryers
Caution! Do not use a hoist to move or rig your Drying/Conveying System when it is
mounted on a cart! Moving the unit with a hoist will cause it to become
unstable and may cause damage to the equipment and/or injury to
personnel!
ON
O
F
F
PROCESS
TEMPERATURE
DEW POINT
CONTROL POWER
ON OFF
ALARM ALARM Silencer
ALARM HORN
DO NOT
USE
USE
FORK
LIFT
TRUCK