User guide
Data and Computer Software Clause at 252.227-7013. If you are sub-
licensing or using the Software outside of the United States, you will
comply with the applicable local laws of your country, U.S. export control
law, and the English version of this Agreement.
CONTRACTOR/MANUFACTURER
The Contractor/Manufacturer for the Software is:
Creative Technology Ltd
31, International Business Park
Creative Resource
Singapore 609921
GENERAL
This Agreement is binding on you as well as your employees, employers,
contractors and agents, and on any successors and assignees. Neither the
Software nor any information derived therefrom may be exported except in
accordance with the laws of the U.S. or other applicable provisions. This
Agreement is governed by the laws of the State of California (except to the
extent federal law governs copyrights and federally registered trademarks).
This Agreement is the entire agreement between us and supersedes any
other understandings or agreements, including, but not limited to,
advertising, with respect to the Software. If any provision of this
Agreement is deemed invalid or unenforceable by any country or
government agency having jurisdiction, that particular provision will be
deemed modified to the extent necessary to make the provision valid and
enforceable, and the remaining provisions will remain in full force and
effect.
For questions concerning this Agreement, please contact Creative at the
address stated above. For questions on product or technical matters, contact
the Creative technical support center nearest you.
ADDENDUM TO THE MICROSOFT SOFTWARE LICENSE
AGREEMENT (WINDOWS 95)
IMPORTANT: By using the Microsoft software files (the “Microsoft
Software”) provided with this Addendum, you are agreeing to be bound by
the following terms. If you do not agree to be bound by these terms, you
may not use the Microsoft Software.
The Microsoft Software is provided for the sole purpose of replacing the
corresponding files provided with a previously licensed copy of the
Microsoft software product identified above (“ORIGINAL PRODUCT”).
Upon installation, the Microsoft Software files become part of the
ORIGINAL PRODUCT and are subject to the same warranty and license
terms and conditions as the ORIGINAL PRODUCT. If you do not have a
valid license to use the ORIGINAL PRODUCT, you may not use the
Microsoft Software. Any other use of the Microsoft Software is prohibited.
6DIHW\,QIRUPDWLRQ
CAUTION: This device is intended to be installed by the user in a CSA/
TUV/UL certified/listed IBM AT or compatible personal computers in the
manufacturer’s defined operator access area. Check the equipment
operating/installation manual and/or with the equipment manufacturer to
verify/confirm if your equipment is suitable for user-installed application
cards.
ATTENTION: Ce carte est destiné à être installé par l’utilisateur, dans un
ordinateur compatible certifié CSA/TUV/UL ou listé IBM AT, à l’intérieur
de la zone définie par le fabricant. Consulter le mode d’emploi ou le
fabricant de l’appareil pour vérifier ou confirmer si l’utilisateur peut y
installer lui-même des cartes périphériques.
1RWLFHIRUWKH86$
FCC Part 15: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, this notice is not a guarantee that interference
will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
try one or more of the following measures:
T Reorient or relocate the receiving antenna.
T Increase the distance between the equipment and receiver.
T Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
T Consult the dealer or an experienced radio/TV technician.
CAUTION: To comply with the limits for the Class B digital device,
pursuant to Part 15 of the FCC Rules, this device must be installed in
computer equipment certified to comply with the Class B limits.
All cables used to connect the computer and peripherals must be shielded
and grounded. Operation with non-certified computers or non-shielded
cables may result in interference to radio or television reception.
0RGLILFDWLRQV
Any changes or modifications not expressly approved by the grantee of this
device could void the user’s authority to operate the device.
1RWLFHIRU&DQDGD
This apparatus complies with the Class “B” limits for radio interference as
specified in the Canadian Department of Communications Radio
Interference Regulations.
Cet appareil est conforme aux normes de CLASSE “B” d’interference
radio tel que spécifié par le Ministère Canadien des Communications dans
les règlements d’interférence radio.
&RPSOLDQFH
This product conforms to the following Council Directive:
T Directive 89/336/EEC, 92/31/EEC (EMC)
'HFODUDWLRQRI&RQIRUPLW\
According to the FCC96 208 and ET95-19
Name: Creative Labs Inc.
Address: 1901 McCarthy Boulevard
Milpitas, CA. 95035
United States
Tel: (408) 428-6600
declares under its sole responsibility that the product
Trade Name: Creative Labs
Model Number: SB0060
has been tested according to the FCC / CISPR22/85
requirement for Class B devices and found compliant with the
following standards:
EMI/EMC: ANSI C63.4 1992, FCC Part 15 Subpart B
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including
interference that may cause undesirable operation.
Ce matériel est conforme à la section 15 des régles FCC.
Son Fonctionnement est soumis aux deux conditions suivantes:
1. Le matériel ne peut étre source D’interférences et
2. Doit accepter toutes les interférences reques, Y compris celles
pouvant provoquer un fonctionnement indésirable.
Compliance Manager
Creative Labs, Inc.
March 16, 1999
SBLMPC.book Page 4 Sunday, September 17, 2000 2:35 PM