User`s guide

Decoder and Remote Control Functions 1-4

TEST button (this

function is only

available on the

Remote Control)

Activates the “test sound” generator that helps you position your speakers and to balance their relative output.

The test sound moves in a circular sequence from the Left speaker, the Center speaker, the Right speaker, then to the

Rear Right speaker, Rear Left speaker and Subwoofer. These are indicated by the LEDs on the volume indicator. All

functions except for the level controls are disabled while the test sound is running.

❑ The test sound lasts three complete cycles. The test output can be stopped at any point by pressing the TEST

button again.

❑ Use the test to be sure that each speaker works before deciding on proper speaker connection and placement.

❑ Adjust the level controls for the Center speaker, Subwoofer and Rear speaker using the SELECT button on the

Decoder so that each speaker achieves a balanced output level with the Left and Right speakers (which provide

a fixed “reference” output level). You can also use the Center, Rear or Subwoofer buutons on the Remote

Control.

Note: Volume levels during the test sequence are lower or higher than during normal operation. You may need

to reduce or increase the master volume before resuming normal playback.

AUDIO Inputs Connects the respective audio source cables — Analog stereo input; and coaxial and optical digital inputs — to the

corresponding sockets.

Decoder/Remote

Control

Function

Left speaker

Center speaker

Right speaker

Rear Right speaker

Rear Left speaker

Subwoofer

During Test Sequence

Repeats for

3 cycles

English.book Page 4 Friday, August 1, 2003 12:04 PM