User Guide

Setting Up Your CD-ROM Drive 2-6
2. Connect the power cable to the CD-ROM drive as shown in
Figure 2-7.
3. Connect the data cable to the CD-ROM drive as shown in
Figure 2-8. Make sure you align the colored wire on the cable
to Pin 1 of the IDE CD-ROM Data Connector.
If you are connecting your drive to your hard disk controller
card, make sure that you use the data cable provided with your
package to connect your drive (see Figure 2-1 on page 2-1).
Figure 2-7: Connecting power cable to your CD-ROM drive.
Figure 2-8: Connecting data cable to your CD-ROM drive.