User`s guide

12
H
Connection To Sound Blaster Live! Via DIGITAL DIN
If your Sound Blaster Live! sound card
includes a Digital I/O card, you can take
advantage of the clear, distortion-free
audio available from its Digital DIN
output.
1. Insert one end of the SPDIF cable into
the DIGITAL DIN output jack on the
Sound Blaster Live! Digital I/O card.
The position of the Digital DIN
connector on the Digital I/O card may
be different from this diagram. The
Digital DIN connector is
the only connector with
a 9-pin configuration.
2. To configure the Sound Blaster Live!
sound card for four speakers refer to
the on-line SBLive! documentation
Note: The FPS2000 Digital will detect
the presence of a plug connected to
the DIGITAL DIN input and give the
DIGITAL DIN input priority. Any
signal present at the AUDIO input will
be ignored. Be sure to remove the
plug from the DIGITAL DIN input if
you wish to listen to a sound source
through the analog AUDIO INPUT.