User`s guide

Table Of Contents

Connecting Other External Devices

Inserting and removing hard drives

Your Tecra

9000 can use 10GB, 20GB, and 30GB hard drives.

Depending upon the original hard drive installed in your computer,

you may wish to increase storage capacity by changing the

internal drive, or you can also add additional hard drive space by

inserting a drive into the select bay module.

To change the internal hard drive.

1 Shut down your computer completely using the Shut Down

command. See “Shutting down the computer” on page 55.

2 Unplug the computer.

3 Close the display panel and remove any cables you may have

connected.

4 Turn the computer upside down.

5 Remove the two screws on the hard drive bay cover.

Removing the hard drive cover screws

6 Lift the hard drive bay cover to expose the hard drive.

7 Grasp the plastic tab on the exposed edge of the hard drive

and pull it to remove the hard drive from the computer.