Instruction manual

accQcomm Interface Module
Section 2 Installation and Operation
2-21
After a few seconds, the LCD will change to display:
Once the accQcomm has moved past the Initializing screens,
communication is possible through the configuration port with
default settings (57600 bps, no parity, 1 stop bit, no Flow
Control), or through the Ethernet port (at IP address
192.168.1.10). Startup will once again use saved settings (if dif-
ferent settings are entered).
2.10 Cleaning The module case may be cleaned with warm water and a mild
detergent.
Avoid getting liquids in the terminal connections or communi-
cation connectors. Do not spray or immerse the module in any
liquids.
CAUTION
Do not immerse the module in a bath for cleaning. The accQ-
comm is not hermetically sealed. If internal components get
wet, the module may be permanently damaged.
USING DEFAULT
SETTINGS