Instruction manual

accQcomm Interface Module
Section 2 Installation and Operation
2-11
Ranges are user-defined using the 4mA and 20mA boxes.
Parameter values will be displayed using the units entered in the
Display Units box on the Site tab (see Section 2.2.2).
Only the analog outputs installed at the factory will be opera-
tional when shipped. If additional outputs are required, call
Teledyne Isco. Regardless of how many analog outputs are
installed in your accQcomm, each channel selection will appear
on the screen as active until you deactivate it by deselecting its
checkbox. When this setting is saved to the accQcomm, the LCD
will indicate that this analog channel has been turned off. For
example, if Channel 3 were deactivated, the accQcomm screen
would display:
Figure 2-9 Output tab: Analog Output settings
#1: x.xx mA
#2: x.xx mA
#3: off
#4: x.xx mA
Check box to use both MODBUS
and Analog outputs.