Instruction manual

accQcomm Interface Module
Section 2 Installation and Operation
2-10
Alternate MODBUS Port Although ordinarily only MODBUS or Analog output (see next
section) can be selected as the Output Type (refer to Figure 2-8
on the following page), an alternate MODBUS port can be used
at the same time as Analog Output.
To activate and configure this port while the Output Type is set
for Analog, check the box next to “Use alternate MODBUS port.”
Note that enabling this alternate port will disable instrument #2.
Figure 2-8 Output tab: MODBUS settings
2.5.2 Analog Selecting Analog (4-20mA) from the pull-down menu activates
the Analog Output and Advanced Analog Calculations settings.
One to four analog outputs can be assigned to any data type from
one to three connected flow meters, including the sums and
averages of readings from all active connected instruments. For a
listing of all available analog output data types, and their defini-
tions, see Table 2-2.