Instruction manual

accQcomm Interface Module
Section 2 Installation and Operation
2-6
2.3 Communication Click the Communication tab to select the appropriate commu-
nication settings for the PC connection and each flow meter.
Figure 2-5 Communication tab
Note
Record your Port and Network settings for future use. If
you attempt to connect with the accQcomm without the correct
configuration baud rate or IP address, you will be unable to
communicate with the unit unless you correct the baud rate or
reset the module to system default settings (see Section 2.9).
2.3.1 Port Settings The default baud rate for the accQcomm’s configuration port is
57600 bps. The default baud rate for the instruments is 9600 bps.
The accQcomm and flow meter baud rates must match for the
instruments to communicate with each other.