User`s guide

Troubleshooting B-3
LED Status Observe the LEDs on your DSL Router to check if the device is functioning properly.
Normal Setup
Status
When your DSL Router is turned on, the Power LED lights up. After several
seconds, all the LEDs will go into their correct states. See "Installing your DSL
Router" on page 1-1 for more information.
The Power LED on my DSL Router does not turn on.
Your DSL Router is not properly powered by an external power source.
Try the following:
❑ Check both ends of the DC adapter cable connection to see if the connectors are firmly
plugged into both the telephone wall outlet and your
DSL Router.
❑ Be sure that you have turned on the power outlet connected to your DSL Router.
❑ Be sure that you are using the power adapter provided.
The Link LED on my DSL Router does not turn on after I connect my DSL
Router and computer with the Straight Ethernet cable.
Your DSL Router is not properly connected to your computer.
Try the following:
❑ Check both ends of the Straight Ethernet cable and be sure that they are plugged in
securely.
❑ Be sure that you have used a Straight Ethernet cable. However, if you are connecting to
more than 2 computers through a hub, you may need to use a crossed Ethernet cable to
connect your DSL Router to your hub.
❑ Be sure that you have configured your Network Interface Card correctly.
The Link LED on my DSL Router is turned on and is unable to access the
Internet.
Your DSL Router may not be properly configured. See topic "My DSL Router does
not connect to the Internet." on page B-2.