User manual

User Manual for Multi-parameter Patient Monitor

 Communication

POWER indicator on CSM Link does not turn on when power is connected:

Check mains is on, otherwise turn on.

Replace power supply. If POWER indicator is still not on, send CSM Link for service.

LINK indicator on CSM L ink does not turn on:

Check that this actual CSM Link is chosen on the CSM.

If CSM cannot find the CSM Link:

Relocate CSM Link to obtain better signal quality.

Turn on RF communication in the CSM.

CSM and Link are connected but no data appears on recording terminal:

Check that the RS-232 is connected.

Check that the recording terminal has the right setup.

8.4 No Blood Pressure and Pulse Oxygen Measures

1. Check if the blood pressure cuff is properly wrapped around the arm according to the operating instructions, if

the cuff leaks, and if the inlet is closely connected with the NIBP jack on the side panel. Check if the indicator

of the pulse oxygen probe flashes and if the pulse oxygen probe is properly connected to the SpO

jack on the

side panel.

2. If the problems still exist, please contact the dealer or manufacturer.