User manual

User Manual for Multi-parameter Patient Monitor

6. Subject with hyperadiposis;

In addition, statistics show that 37% people report blood pressure difference of no less than 0.80kPa(6mmHg)

between the left and right arms, and 13% people report difference of no less than 1.47kPa (11mmHg).

Note: Some practitioners may report big discreteness or abnormal value of the blood pressure measures

when the oscillating method is used. As a matter of fact, the so-called “big discreteness” must be a

term in the sense of statistical significance of mass data. Abnormal data may be observed in some

individual cases. It is normal in the scientific experiments. It may be caused by an apparent reason,

or by an unknown factor in some cases. Such individual doubtful experimental data may be

identified and eliminated using the special statistical technique. It is not a part of this manual. The

practitioner may eliminate the apparently unreasonable data according to the experience.

Operation Introduction:

1. Take a measurement in manual mode:

 Enter into the screen of NIBP setting, select “Mode” option and set it as “MANU”, and then

press the NIBP key on the front panel to start measure. If press the NIBP key again, the

measurement will be stopped.

 During the automatic measurement interval when no NIBP measurement is taken, press the NIBP

key, a measurement in manual mode will be taken. If at this time press the NIBP key again, the

manual mode will be stopped and continue the automatic mode.

2. Take a measurement in automatic mode:

Enter into the screen of NIBP setting, select “Cycle” option and select time interval according needs,

then press the NIBP key on the front panel to start the automatic measurement at a certain interval.

3. Stop automatic measurement

In the procedure of automatic measurement, press the NIBP key at any time, the measurement will be

stopped.

4. STAT measurement

Enter into the screen of NIBP settings, select Cycle option and set as STAT, the STAT measurement will

be taken. This procedure will last for 5 minutes.

5. Stop STAT measurement on the halfway

In the procedure of STAT measurement, press the NIBP key at any time, the measurement will be stopped.

7.4 SpO2/Pulse Monitor

7.4.1 SpO2 Monitor

This monitor measures the pulse oxygen saturation (SpO

) and pulse by means of the radiograph of infrared light

and the red light emitted by LED through body’s peripheral areas (such as fingers), whereby the photoelectric

detecting circuits will analyze the absorptivity of the oxyhemoglobin and reduced hemoglobin respectively, and

give the photoabsorption rates before and after pulsation. Using the measure of photoabsorption change due to

pulsatory arterial blood flow caused by PLETH waveform, the SpO

can be obtained.

7.4.2 Points to be Noted in SpO2 and Pulse Measuring

1. The fingers should be properly placed (see the attached illustration of this instruction manual), or else it

may cause inaccurate measurement result.