User manual

User Manual for Multi-parameter Patient Monitor
25
Last, press the Navigation Knob again. The screen shows “ST+0.xxx mV, Set ST, Dirc Ver”. Rotate the knob to
move the ST point vertically to the point to be measured on the ST segment.
One the main screen allows pressing the Freeze key to enter the ST segment analysis screen.
NOTE: The S point is the end point of S wave, and the T point is the start point of T wave.
☞ The printing is determined by the option of CSM item on Print Setup Screen if you press the Print Key, refer
to Chapter 4.9.2 Printer Parameter Settings for details.
4.3 Mode Selection Screen
Press the Navigation Knob in the main screen as shown in Figure 4.2, the operating area shows the mode selection
screen, as shown in Figure 4.12.
Figure 4.12 Mode Selection Screen
In the mode selection screen, rotate the knob to move the gray cursor to the corresponding screen. Press the knob
to enter the screen of SpO
2
List, NIBP List, TREND, RCALL, VPC, SETUP, COLOR, FILE, and EVENT. Start
from Chapter 4.4 these modes are described in turn. Press “Exit” or Display Key to exit from this screen.
☞ The printing is determined by the option of CSM item on Print Setup Screen if you press the Print Key, refer
to Chapter 4.9.2 Printer Parameter Settings for details.
4.4 SpO
2
Data List Screen
Move the gray cursor to SpO
2
List in the mode selection screen, and press Navigation Knob to enter into SpO
2
data list screen, displays in the same position shown as Figure 4.13.
Figure 4.13 SpO
2
List