User manual

User Manual for Multi-parameter Patient Monitor

The conductive parts of sensors and their connectors, including the neutral sensor, should not contact other

conductive parts including earth.

The monitor will not render accurate readings when used on patients with severe neurological disorders and

patients under 2 years of age.

The use of pacemakers might cause either long periods of artefacts or elevated CSI values.

3.4.5TEMP Transducer Connection

Multi-parameter Patient Monitor has two TEMP transducers to measure different body temperature.

Connecting methods:

1. Attach the transducers to the patient firmly;

2. Connect them to TEMP1” or “TEMP2” on the right panel.

Note: When unplugging the probe, be sure to hold the head of the connector and pull it out.

3.4.6 Battery Installation

1. Make sure that monitor doesn’t connect to mains power supply and stays in switch-off status.

2. Open the battery cover, insert the battery into any slot of battery compartment, and pay attention to the

instruction of polarity direction in the compartment. Do not reverse the battery.

3. Move baffle plate with hand to fasten the battery.

4. Remove the battery cover. (According to your need, you can insert one more storage battery to prolong

using time.)

 Please take out the battery from battery compartment, if it won’t be used for a long time.

3.4.7 Loading Printing Paper

This description is for loading paper for the built-in printer.

Operation procedures:

1. Press both “OPEN” notches with force on printer shield with two thumbs to open it.

2. Move the tab of rubber roller lock at the left 90°upwards to unlock it.

3. Cut one end of the paper into triangle, and load the paper from the underside of the rubber roller.

4. Turn the roller clockwise to get the paper rolled, and put the paper roll into the compartment.

5. Pull the paper out of paper slot on the shield.

6. Move the tab of the rubber roller lock 90° downwards to lock it.

7. Put the shield back in position and secure it.