User manual

User Manual for Multi-parameter Patient Monitor
11
 How to select menu settings from Display Mode
1. Remove battery lid.
2. From any Display Mode, press any arrow on the Control key (9).
3. The top menu appears.
4. Note: The last menu used is chosen.
 How to set parameter values
1. Press the Control key (9a) to select menu.
2. Press the Control key (9b) to enter submenu.
3. Press the Control key (9a) to select parameter.
4. Press the Control key (9b) to highlight parameter value.
5. Press the Control key (9a) to select parameter value.
6. Press the Control key (9b) to store setting or (9c) to cancel the selection and return without
any change.
7. Press the Control key (9c) to go back in one menu level steps.
If the Control key has not been activated in 20 sec. the CSM returns to Operation Display Mode.
Note: The change of settings will only be stored for future use after returning to Operation Display Modes.
 Settings
Menu Parameter Description Values(Default)
Alarm
High Alarm Selects the CSI Alarm High Option ON/OFF(OFF)
Low Alarm Selects the CSI Alarm Low Option ON/OFF(OFF)
High Limit Selects the CSI High Alarm Level 2-99（60）
Low Limit Selects the CSI Low Alarm Level 1-98（40）
Config
Language Select device language English
Contrast Select display contrast 10-30（20）
RF interface
Select radio link active. If turned OFF the
link is completely inactive.
ON/OFF(OFF)
Auto Link Active Auto Link Option Active/Inactive(Active)
 Device Information:
Select Submenu.