User guide

Windows 98 Multi-Monitor Display Problems
The monitor connected to the second or successive Banshee card remains
blank even though the card and its drivers have been installed.
If you do not specify Banshee’s drivers during the software installation
(see “Installing in Windows 98” on page 4), the system installs the
second or successive Banshee card as a VGA card which does not
support Windows 98’s multi-monitor feature.
Update the device drivers to Banshee’s drivers:
1. Right-click your desktop, and then click Properties on the
shortcut menu.
2. In the Display Properties dialog, click the Settings tab.
3. On the Settings tab page, click the Advanced Properties button.
4. In the Advanced Display Properties dialog, click the Change
button.
5. In the Select Device dialog, click the Have Disk button.
6. Insert the 3D Blaster Banshee CD into your CD-ROM drive.
7. Follow steps 6 through 13 of the procedure in “Installing in
Windows 98” on page 4 to complete the update.
Other Display Problems
Monitor display flickers after Windows 95 or Windows 98 starts.
Your monitor may not support the resolution or refresh rate that you
have set.
Use display settings supported by the monitor.
To change the display settings:
1. Restart your system in Windows 95/ Windows 98
Safe mode
.
To do so:
a. Restart your system and when the message “Starting
Windows 95...” or “Starting Windows 98...” appears, press
F8.
A list of options such as Safe Mode and Command Prompt
Only Mode appears.
b. Select Safe Mode and press ENTER.