User guide

2-6 Installing Software
6. Insert the 3D Blaster Banshee CD into your CD-ROM drive.
7. In the Install From Disk dialog, type
D:\WINNT40
(where D:
represents your CD-ROM drive) and click the OK button.
8. In the Display list box, select the 3D Blaster Banshee drivers.
9. Click the OK or Close button until you are prompted to restart
your system, and then click the Yes button.
10. If the Invalid Display Settings message box appears after your
system has restarted, click the OK button and change the display
settings.
For details, see “Changing Display Settings in Windows NT
4.0” on page 2-6.
11. Proceed to install the applications.
Click the Start button on your taskbar, and then click Run.
12. In the Run dialog, type
D:\WINNT40\SETUP
and click the OK
button.
13. Follow the instructions on the screen to complete the setup.
If you do not install all the applications now, you can install
them later.
Changing Display Settings in Windows NT 4.0
1. Right-click your desktop, and then click Properties on the
shortcut menu.
2. In the Display Properties dialog, click the Settings tab.
3. In the Desktop Area group box, move the slider to set the
desired resolution.
4. In the Color Palette group box, select the desired color. Certain
colors may not be available for some display resolutions.
5. In the Refresh Frequency group box, select the desired refresh
rate.
6. To test the settings, click the Test button, and then click the OK
button. When the Testing Mode dialog re-appears:
!If the test bitmap is properly displayed, click the Yes button.
!If not, click the No button. A warning message will be
displayed. Click the OK button and repeat steps 3 through 6,
changing one or more of the settings.
7. Click the OK button to close the Display Properties dialog.