Product guide

6 3D Blaster™ Savage 4
10. Connect the monitor cable to the VGA Out connector of 3D Blaster Savage4, as
shown below.
Installing
Software
After installing the graphics card, you can install the software. The 3D Blaster Savage4 CD
contains the following:
Drivers for Windows 95/98 (common to both)
Drivers for Windows NT 4.0
Creative Enhanced BlasterControl for Windows 95/98 and Windows NT 4.0
Creative SoftMPEG for Windows 95/98
S3 METAL drivers
OpenGL ICD driver for Windows 95/98 and Windows NT 4.0
Colorific™ for Windows 95/98 and Windows NT 4.0
3Deep™ for Windows 95/98 and Windows NT 4.0
This section is organized as follows:
To install in Windows 95 (Retail version)
To install in Windows 95 (OSR version 2.1 and later)
To install in Windows 98
To install in Windows NT 4.0 (Service Pack 3)
If you are using a multi-
frequency monitor, you may need
a special 15-pin PS/2-compatible
adapter cable. If your multi-
frequency monitor allows you to
switch between ‘TTL’ and
‘analog’ operation modes, set the
switch to ‘analog’. For details,
refer to your monitor’s manual.
Figure 4: Connecting your VGA monitor to 3D Blaster Savage4.
Monitor
Output
connector
3D Blaster
Savage4
VGA
Monitor
cable
VGA monitor