Installation guide

3D Blaster RIVA TNT2 PCI Installation Guide 9
Changing
Settings
To change the
display settings in
Windows NT 4.0
1. Right-click your desktop, and then click Properties on the shortcut menu.
2. In the “Display Properties” dialog box, click the Settings tab.
3. In the “Desktop Area” group box, move the slider to set the desired resolution.
4. In the “Color Palette” group box, select the desired color. Certain colors may not be
available for some display resolutions.
5. In the Refresh Frequency group box, select the desired refresh rate.
6. To test the settings, click the Test button, and then click the OK button.
When the Testing Mode dialog box re-appears:
• If the test bitmap is properly displayed, click the Yes button.
• If not, click the No button. A warning message will be displayed. Click the OK button
and repeat steps 3 through 6, changing one or more of the settings.
7. Click the OK button to close the “Display Properties” dialog box.
To change the
performance settings
in Windows 95/98
and Windows NT 4.0
To do so in Windows 95 and Windows NT 4.0:
1. Right-click your desktop, and then click Properties on the shortcut menu.
2. In the Display Properties dialog box, click the BlasterControl tab.
3. On the BlasterControl tabbed page, click the Tweak icon.
4. In the Tweak module, select the desired settings.
5. To specify additional settings for 3D Blaster RIVA TNT2 PCI, click the Advanced Settings
button.
6. Select the desired settings and click the OK button.
To see a brief description of an option or check box in the BlasterControl Tweak module,
right-click the item, and then click What’s This.