Installation guide

3D Blaster RIVA TNT2 PCI Installation Guide 5
9. Connect the monitor cable to the VGA Out connector of 3D Blaster RIVA TNT2 PCI, as
shown in the figure below.
10. Replace the computer cover and plug the power cord back into the wall outlet.
Installing
Software
After installing the graphics card, you can install the software. The 3D Blaster RIVA TNT2
PCI CD contains the following:
❑ Drivers for Windows 95/98 (common to both)
❑ Drivers for Windows NT 4.0
❑
Creative Enhanced BlasterControl™ for Windows 95/98 Windows 2000 and Windows NT 4.0
To install in
Windows 95
(Retail version)
1. Switch on your system.
Windows 95 automatically detects the graphics
card.
A “New Hardware Found” message box appears,
informing you that a display adapter has been
detected.
2. When a dialog box similar to Figure 5 appears,
ensure that the Driver from disk provided by
hardware manufacturer option is selected.
3. Click the OK button.
If you are using a multi-
frequency monitor, you may need
a special 15-pin DIN VGA
adapter cable. If your multi-
frequency monitor allows you to
switch between ‘TTL’ and
‘analog’ operation modes, set the
switch to ‘analog’. For details,
refer to your monitor’s manual.
VGA Out
connector
VGA Monitor
cable
VGA monitor
3D Blaster RIVA
TNT2 PCI