Installation guide

3D Blaster RIVA TNT2 PCI Installation Guide 3
Important for
Windows 95 users
Before installing the graphics card, you need to know which version of Windows 95 you have
so that you can select the relevant installation procedure later. This is because the installation
procedure in each version of Windows 95 is different.
To verify your Windows 95 version number
1. Click Start, select Settings, click on Control Panel.
2. In the Control Panel window, double-click the System icon.
Your Windows 95 version number is displayed on the General tabbed page of the System
Properties dialog box.
3. Note the version number.
The following are the possible Windows 95 version numbers:
❑ 4.00.950 (Retail version)
❑ 4.00.950A (Retail version)
❑ 4.00.950B (OSR version 2 and 2.1)
❑ 4.00.950C (OSR version 2.5)
Installing Your 3D
Card
The figure below shows you the connectors on the 3D Blaster RIVA TNT2 PCI card.
Check the appropriate box so that
you can refer to the Windows’
version number quickly during
the software installation process.
PCI bus connector
VGA Out connector
Connects to your monitor via a monitor cable.
Video Expansion connector
Connect to a video expansion board.