User manual

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Contents
ii
8.1.3 Setup Menu—7: EDID, Assignment to an Input 28
8.1.4 Setup Menu—9: Delay, Setting for an Output 29
8.1.5 Setup Menu—4: store setup XX, Storing the Setup in a Preset 29
8.1.6 Setup Menu—6: recall setup XX, Recalling a Preset 30
8.2 Using the Config Menu 31
8.2.1 Config Menu—Input Signal Detection Display 32
8.2.2 Config Menu—Setting Input Port Parameters 32
8.2.3 Config Menu—Output Load Detection Display 36
8.2.4 Config Menu—Setting Output Port Parameters 36
8.2.5 Config Menu—Interface Configuration 41
8.2.6 Config Menu—Interface Reply Configuration 42
8.2.7 Config Menu—Protocol Switching 42
8.2.8 Config Menu—Store Default Setup 43
8.2.9 Config Menu—Total Matrix Reset 44
8.2.10 Config Menu—Display Firmware Versions 45
9 Configuring the Number of Installed Input and Output Ports 45
10 Installing and Using the Test Module to Troubleshoot Video Problems 46
10.1 Installing the Test Module 46
10.2 Setting the Resolution of the Generated Video 47
10.3 Setting the Pattern of the Generated Video 48
10.4 Using the Test Module to Troubleshoot Video Problems 48
10.4.1 Testing the Projector Output 48
10.4.2 Testing the Output Signal Path to the Projector 49
10.4.3 Testing the Input and Output Signal Path to the Projector 49
11 I/O Card Hardware Installation Instructions 49
12 Upgrading the VS-1616D Firmware 51
13 Technical Specifications 52
14 Default Communication Parameters 54
15 Factory Default EDID 54
15.1 DVI Input Card 54
15.2 HDCP Input Card 55
15.3 HDMI Input Card 57
15.4 HDMI plus Audio Input Card 59
15.5 DVI Dual Channel Input Card 61
15.6 DGKat Input Card 62
15.7 HDBaseT Input Card 64
15.8 VGA Input Card 66
16 Communication Protocols 67
16.1 Protocol 3000 67
16.1.1 Kramer Protocol 3000 Syntax 67
16.1.2 Device Message Format 68
16.1.3 Command Terms 68
16.1.4 Entering Commands 69