User's Manual

19
Date of Origin – 02/01/08
PROGRAMMING EASY FLOW HOPPER DOORS
1. Power up the control box. (Hold the Open and Close” buttons on the control box for 3 seconds
or until control box light comes one to indicate the control box is activated.)
2. Open transmitter and observe flashing light.
3. Push “MODE” button to select “Front Hopper” Mode (First two lights flashing).
4. Repeat steps 1 and 2 for each transmitter to be programmed. One to four transmitters can be
programmed. All transmitters are to require to be programmed while light is flashing.
5. Push and hold “Programming /Work Light” button on control box, for approximately 8 seconds,
until the illuminated light on the control box starts flashing.
6. Press the “ON/OPEN” button on each transmitter to be programmed. Four transmitters can be
programmed to each control box so four inputs are required. If one transmitter is being
programmed, the “ON/OPEN” button will required to be pushed four times. If two transmitters are
being programmed then the last transmitter will be required to press the “ON/OPEN” button
three times. The light on the control box will stop flashing and stay illuminated when the four
inputs have been received.
7. Close lid of programmed transmitters to power down transmitters.
8. Power down control box. (Hold the Front Hopper “Open and Close” buttons for 3 seconds or
until control box light goes off.)