User's Manual

18
Date of Origin – 02/01/08
CONTROL BOX OPERATION, MANUAL OPERATION
1. Turn on Master Disconnect Switch in the tractor.
2. Power up Control Box. (Hold the Front Hopper “Open” or “Close” buttons on the control box
for 3 seconds or until control box light comes on to indicate the control box is activated.)
3. Select button to perform the required operations.
4. Power off Control Box when finished. (Hold the Front Hopper “Open” or “Close” buttons on
the control box for 3 seconds or until control box light goes off.)
SETTING FUCTIONS ON REMOTE:
Setting function allows functions to be blocked if not required/not going to be used.
1. Open transmitter. Observe flashing light.
2. Press and hold “MODE” button for 10-12 seconds until the top light stays lit.
3. Press the “ON/OPEN” button if this function will be used. Select and press the “OFF/CLOSE”
button if you want this function to be skipped.
4. Repeat Step 3 for all five functions.
a. 1 LIGHT - TARP SYSTEM
b. 2 LIGHTS - FRONT HOPPER
c. 3 LIGHTS - REAR HOPPER
5. When the last function has been selected, the light on the first mode function will stay lit for
approximately 3 seconds to indicate active and return to flashing when process is complete.
d. 4 LIGHTS - AUXILIARY
e. 5 LIGHTS - AUXILIARY
OFF/CLOSE Button
Control Box Light
OPEN Button
CLOSE Button
MODE Lights
ON/OPEN Button
MODE Selection
Button
!
WARNING! Make sure all power supply to trailer is disconnected and the ground
wire in the nose of the trailer and on the receiver box is disconnected prior to any
welding on trailer. Failure to do so could result in damage to receiver control box!!