User's Manual

WIRELESS TRANSMITTER PROGRAMING INSTRUCTIONS
Shur-Co.
P.O. Box 713, 2309 Shur-Lok Street Yankton, South Dakota 57078
Call Toll Free: 1-866-748-7435 Fax: [phone] Web Site: http://www.shurco.com
P/N 1118435 Rev. A
Power-up/down:
The transmitter will power up when the lid is opened.
The transmitter will power down when the lid is closed,
or when the lid is left open 3 minutes after the last but-
ton is pushed.
Standard Operation:
After power-up, the first channel will be immediately ac-
tive and the LED indicator for this channel will be flash-
ing. The Open/On and Close/Off buttons are operational
for the indicated active channel. While pressed, the LED
indicator will flash faster indicating channel operation.
The Select button will cycle between enabled channels.
If only one channel is enabled, there will be no apparent
change when the Select button is pressed.
Channel Programming Mode:
The Shur-Co transmitter has 5 channels. Pressing the
Select button toggles through these channels. Unused
channels can be disabled if desired, using the follow-
ing process, but your transmitter is fully operational as
shipped. This process may be skipped. Unused trans-
mitter channels will not perform any functions.
Hold the Select button down for 10 seconds, and the
transmitter will enter Channel Programming Mode.
Each time Channel Programming Mode is entered, the
status of all five channels must be reset.
While In Channel Programming Mode, the program-
mable channel will be indicated by a solid lit LED.
NOTE: The transmitter will NOT activate any motor or
lighting system while the transmitter is in Channel Pro-
gramming Mode .
Press the Open/On button to enable the current channel
(designated by the indicator light). Press the Close/Off
button to disable the current channel. The indicator light
will automatically jump to the next channel.
After programming all five channels, the transmitter will
display the programmed channel status for all channels
for 3 seconds. All enabled channel LEDs will be lit solid
and all disabled channel LEDs will not be lit. Buttons
will not function during this 3 second period.
The transmitter will automatically exit Channel Program-
ming Mode after 3 seconds and return to Operational Mode.
NOTE: If there is not at least one enabled channel
after programming, the transmitter will not save the
changes and will revert back to the previously saved
channel settings.
TIP: To cancel your changes and exit Channel Program-
ming Mode, close the transmitter cover.
Channel Programming Example:
The transmitter in this example is labeled with the fol-
lowing five channels:
•Tarp฀System
•Front฀Hopper
•Back฀Hopper
•Lights
•Aux
These channel labels are for a standard agricultural
transmitter. Your transmitter label may differ.
The task is to enable the Tarp System, Front Hopper
and Back Hopper channels.
1. Hold down the Select button for 10 seconds. The
transmitter will enter Learn Mode. The Tarp System
channel LED will be lit. All other channel LEDs are off.
2. Press the Open/On button to enable the Tarp System
channel. The Front Hopper LED will now be lit.
3. Press the Open/On button to enable the Front Hop-
per. The Back Hopper LED will be lit.
4. Press the Open/On button to enable the Back Hop-
per. The Lights channel LED will be lit.
5. Press the Close/Off button to disable the lights. The
auxiliary LED will be lit.
6. Press the Close/Off button to disable the Aux chan-
nel LED.
7. The transmitter will display all activated channels
for 3 seconds. The transmitter will automatically exit
Channel Programming and revert to Operational Mode.
The Tarp System LED will be flashing, indicating that
the channel is active and ready for operation.