User's Manual Part 3

65
Pre-Ride Inspections
Front Suspension
Inspect the front forks for oil leaks or damage, and verify
smooth suspension operation. See page 92.
Steering
1. On level ground, straddle the motorcycle and bring it to
the fully upright position. Turn the handlebars from stop
to stop. The action should be smooth, but not loose.
2. Make sure wires, hoses and control cables do not
interfere with smooth steering.
Rear Suspension
Check the rear shock absorber mounting and inspect for
leaks. See your dealer for service if you discover leaks or
malfunction of any kind. See page 88.
CHIEFTAIN only: Check rear shock absorber movement and
air pressure to ensure the correct amount of suspension
travel and ground clearance. See page 90.
WARNING! Inadequate ground clearance could result in
components contacting the ground, causing loss of control and
serious injury or death. Always ensure ground clearance is at
specification.
Rear Drive Belt
1. Check drive belt tension. See pages 86-87.
Tip: The drive belt system must be cool, clean and dry to accurately
measure belt tension (deflection). Do not measure belt tension
when the belt or drive system is wet or when it is hot (such as
immediately after riding).
2. Check the drive belt teeth for stones or other debris.
3. Inspect drive belt condition. See page 87. If you
discover cracks, broken teeth or frayed edges, replace
the drive belt before riding. See the INDIAN
MOTORCYCLE Service Manual or an authorized INDIAN
MOTORCYCLE dealer.
Fuel Level
The fuel gauge displays fuel level. For the most accurate
reading, sit on the motorcycle and bring it to the upright
position.