User's Manual

ADDICT v3.0.1 User Manual DALI Functionality
©2017 All rights reserved - 22 -
Scenes
Each DALI device can have store up to 16 scene levels, and the Config Scenes menu contains
three functions for setting up these scene levels.
Set Scenes
Set Scenes allows scene levels to be set for both addresses and groups, and follows a similar
approach to Config Groups:
When an address is selected, the level for the currently selected scene is displayed, as well as
either the percentage or “MASK” (mask means take no action in relation to the Scene). For
groups, current levels can’t be displayed because DALI doesn’t work that way, but the scene
level can still be set (and can be checked if desired by selecting an address that is assigned to
that group).
When a current scene level is displayed or a new level is selected, a message is also displayed
indicating if the level is above the maximum level or below the minimum level for the selected
address (but not when a group is selected).
If Live Preview is enabled:
• Selecting an address/group will cause that address/group to be set at maximum and all
others at minimum
• Selecting a scene will cause that scene to be recalled for the selected address/group
• Selecting a level will cause a “Go to level” command to be sent to the selected
address/group.
Selectable values:
• Address/Group (Address:0-63 and Group:0-15, ALL) – The address or group of the
device(s) to configure the scenes for.
• Scene (0 – 15) – The scene being configured
• Level (0 – 255) – The scene level. Pressing enter will save any changes made to the
selected scene level.
Copy Scenes
Copy Scenes allows for scenes to be copied between devices.
To copy scenes, a source device and scene and a target device and scene must be selected. It is
also possible to select groups as a source/target device and all scenes as a source/target scene.