User's Manual

button on the RF Receiver.
Item 6.9: Battery
6.9.1 Battery Type
The mouse use two AA alkaline batteries.
6.9.2 Battery Consumption
Operating mode: ＜40mA @ 3.0V （white paper）
Sleep Mode 1: <4.0mA @ 3.0V (white paper) If the mouse is not used for approximately 3 seconds.
Sleep mode 2: <0.5mA @ 3.0V (white paper)when not in use for approximately 8 minutes.
6.9.3: Battery saving mode : longer battery life
6.9.4: LED Indicator Function.
6.9.51: Low Battery indication
If the blue LED on the receiver is flashing while working, this indicate that the battery is low in
voltage, you will need to change the batteries.
6.9.52: Indication of mouse function:
1)Receiver LEDdoesnotlight up when it is connected to the PC
2) LED will flash for about 10 seconds when connected.
3) LED will light up when the mouse is being used.
4) LED will not light up when there is no mouse movement or when the buttons are not clicked.
Item 6.10: Tracking Speed
The unit shall be capable of tracking between50mm/s and 350mm/s of hand movement on the matt
white paper without loss of data.
Item 6.11: Mouse Sensor Features
- Optical motion estimation technology
- Complete 2D motion sensor
- No mechanical moving parts
- Accurate motion estimation over a wide range of surfaces
- High speed motion detection up to 14 inches/sec
- High resolution up to 800cpi
Part 7.0: Reliability and environmental specification
Item 7.1: Button SwitchActivation
Condition: 3 cycles per second.
Testing method: a small DC motor fixed with cam automatically presses the button for three times per
second. The switch isconnected to a calculator. The number displayed on the
calculator shows the pressed cycle of the button.
Result: button tested have a liftcycle of more than 1,000,000.00.
Item 7.2 : Cable Bending Strength
Condition: Cable load at 100gram,
Testingmethod: bend 60 degrees in any direction from its centerlineat a speed of 30 cycles/min. 1000
cycles.
DR： Sam CHECK： APPD：