User's Guide
SAFETY & REGULATORY INFOMATION
The following sections contain notices for various countries.
CAUTION:
This product is intended for use with FCC/CE certified computer equipment. Please check
the equipment operating/installation manual and/or with the equipment manufacturer to
verify/confirm if your equipment is suitable prior to the installation or use of the product.
Notice for USA
Federal Communication Commission (FCC) Interference Statement
FCC Part 15: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protectionagainst harmful interference in a residential installation. This equipment generates, uses
and canradiate radio frequency energy and, if no installed and used in accordance with instructions,
may causeharmful interference to radio communications. However, there is no guarantee that
interference will notoccur in a particular installation. If this equipment does cause harmful interference
to radio or televisionreception, which can be determined by turning the equipment off and on, the user
is encouraged to tryto correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver
isconnected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subjected to the following two
conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause
undesiredoperation.
CAUTION: To comply with the limits of the Class B digital device, pursuant to Part 15 of the FCC
Rules,this device must be installed with computer equipment certified to comply with Class B limits.
All cables used to connect to the computer and peripherals must be shielded and grounded.
Operationwith non-certified computers or non-shielded cables may result in interference to radio or
televisionreception.
MODIFICATION: Any changes or modifications not expressly approved by the grantee of this device
could void the user's authority to operate the device.
Federal Communication Commission (FCC) Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Creative Outlier One V2 (EF0850) Additional Safety and Regulatory information










