User's Manual

ManualsBrandsCreative Labs ManualsElectronicsCreative Hitz WP380

Technical Speciﬁ cations:

•

Driver: 34mm Neodymium magnet

•

Frequency Response: 18Hz ~ 22kHz

•

Impedance: 32ohms

•

Wireless Technology: Bluetooth v3.0

•

Bluetooth Proﬁ les: A2DP, AVRCP, HSP, HFP (HD Voice ready)

•

Audio Codec: aptX, AAC, FastStream*, mSBC, SBC

•

Content Protection: SCMS-T

•

Operating Frequency: 2402 ~ 2480 MHz

• Operating Range: Up to 10m / 33ft

• Power Supply: Rechargeable Lithium Ion battery, 3.7V, 430mAh

• Charge via USB: 5VDC, 500mA

• Charge Time / Play Time / Talk Time: 2 hours / 12 hours / 14 hours

• Net Weight: 150g / 5.3oz

* FastStream allows low latency wireless bi-directional audio streaming and voice communication with

Creative BT-W1 Bluetooth USB transceiver

HD Voice requires supported smartphones and mobile networks.

4. Right earcup indicator

5. Left earcup indicator

6. Micro-USB charging

connector

7. Audio Input connector

8. Invisible Microphone

9. NFC (Near Field

Communication) pad

Green and blinks slowly: ready to connect a device.

Green and blinks rapidly: attempts to connect to a Creative

ShareMe headset.

Blue and blinks slowly: connected to a paired device.

Blue and blinks rapidly: in pairing mode and is ready to pair

with a new device.

Blue and green blinks simultaneously: in an active Creative

ShareMe connection.

Red and ﬂ ashes once: powering off the headset.

Red and blinks slowly: low battery level, charge the headset

soonest.

Red: charging headset. This goes off when headset is fully

charged.

Use the supplied USB cable for charging the headset via a

laptop or computer.

Use the supplied audio cable for a wired connection to non-

wireless devices or when battery power runs out. Connect the

smaller 2.5mm diameter plug to the headset (align the triangular-

shaped connector properly) and the larger 3.5mm diameter plug

to your audio device.

Noise suppression microphone for crystal clear communications.

Tap your NFC-enabled mobile devices here to establish

Bluetooth pairing and connection. Tap again to end connection.

Light Indicator

Connector / Port

Function