User's Manual
Table Of Contents
- About Your MovieWorks HD
- About Your Remote Control
- Setting Up Your MovieWorks HD
- Playing Music or Videos From Your iPod
- Using Your MovieWorks HD
- Using the On-Screen-Display (OSD)
- Using Wireless Features
- Using X-Fi Enhancements
- Connecting Headphones
- Connecting To An External Stereo Audio Source
- FAQs
- General Specifications
- Safety Information
- Declaration of Conformity
- Regulatory Information
Using Your MovieWorks HD 12
Turning on MovieWorks HD or enabling Standby mode
Press the Power/Standby button on your remote control to turn on
MovieWorks HD or enable Standby mode. For Power/Standby LED
information, see “Understanding the Power/Standby LED” below.
Returning to factory default settings
Press and hold the Power/Standby button on your MovieWorks HD while you
connect the power jack or plug the power adapter to the power outlet. The
Power/Standby LED changes from red to white and remains lighted up in
white. During a reset, MovieWorks HD reverts to the original volume setting,
and turns on the X-Fi enhancements to default levels. If your MovieWorks
HD is paired with any Creative Wireless Receiver, the zone control settings
are also erased.
Understanding the Power/Standby LED
NOTE
You can also press the Power/Standby button/LED on MovieWorks
HD.
LED Behavior Status
White Stable Turned on and ready for use
Red Stable In Standby mode
Stable (Red) -> Stable (White) Establishing wireless connection
Quick flashing (twice) Receiving remote control signals
Continuous slow flashing Muted
NOTES
For information on the Link LED, see the Creative Wireless
Receiver User’s Guide.