User's Manual
Table Of Contents
- Creative Sound Blaster Wireless Entertainment
- Contents
- Introduction
- Your Sound Blaster Wireless Entertainment At A Glance
- Getting Started
- Using Your Remote Control
- About Music Files
- Frequently Asked Questions
- Maintenance and Safety Advice
- Technical Specifications
- Glossary
- Ad-hoc mode
- Antenna
- Access Point (AP)
- Bandwidth
- BSS (Basic Service Set)
- DHCP (Dynamic Host Configuration Protocol)
- Dynamic IP address
- Encryption
- IEEE 802.11
- IEEE 802.11b
- IEEE 802.11g
- Infrastructure mode
- IP (Internet Protocol)
- IP address
- LAN (Local Area Network)
- MAC (Media Access Control) address
- Router
- SSID (Service Set Identity)
- Static IP address
- TCP/IP (Transmission Control Protocol/ Internet Protocol)
- USB (Universal Serial Bus)
- WEP (Wired Equivalent Privacy)
- Wi-Fi
Technical Specifications D-1
Technical Specifications
Wireless MP3
Receiver
Standards ❑ IEEE 802.11b
Interface ❑ USB 1.1 port for Wireless MP3 Receiver installation and configuration
❑ Two RCA jacks for analog output
❑ Optical connector for optical SPDIF output
Antenna ❑ Built-in antenna (2.4 GHz)
Frequency Band ❑ 2.412–2.462 GHz
Data Rate ❑ 11, 5.5, 2, 1 Mbps
Channels ❑ 11 Channels (US, Canada), 13 Channels (Europe), 14 Channels (Japan)
Security ❑ 64 or 128-bit WEP encryption
Range ❑ Up to 30 meters (98 feet), depending on the signal strength of your wireless network
Playback Formats ❑ MPEG Audio Layer 3 (MP3) and Windows Media Audio (WMA)
Power Adapter ❑ 6VAC 1.5A adaptor