User's Manual
Table Of Contents
- Creative Sound Blaster Wireless Entertainment
- Contents
- Introduction
- Your Sound Blaster Wireless Entertainment At A Glance
- Getting Started
- Using Your Remote Control
- About Music Files
- Frequently Asked Questions
- Maintenance and Safety Advice
- Technical Specifications
- Glossary
- Ad-hoc mode
- Antenna
- Access Point (AP)
- Bandwidth
- BSS (Basic Service Set)
- DHCP (Dynamic Host Configuration Protocol)
- Dynamic IP address
- Encryption
- IEEE 802.11
- IEEE 802.11b
- IEEE 802.11g
- Infrastructure mode
- IP (Internet Protocol)
- IP address
- LAN (Local Area Network)
- MAC (Media Access Control) address
- Router
- SSID (Service Set Identity)
- Static IP address
- TCP/IP (Transmission Control Protocol/ Internet Protocol)
- USB (Universal Serial Bus)
- WEP (Wired Equivalent Privacy)
- Wi-Fi
Getting Started 3-3
2. Connect your Wireless MP3 Receiver to speakers or a home stereo system
(both available separately).
3. Connect your Wireless MP3 Receiver to a power outlet using the supplied
power adapter, and turn on the power of the power outlet (if necessary).
Step 4: Play
Music
1. Insert three AA batteries into the Remote Control and press the Power button
on your Remote Control.
2. Click the Play button on your Remote Control to start playing songs that are
in the Now Playing List.
3. Press the Volume buttons on your Remote Control to increase or decrease the
volume.
4. After you have finished using Sound Blaster Wireless Entertainment, press the
Power button on your Remote Control to set your Wireless MP3 Receiver to
standby.
For more information about using the Remote Control, refer to "Using Your Remote
Control" on page 4-1.
Figure 3-3