Installation & Assembly

Octagonal Sand

Pit

Assembly Instructions

MODEL #7120

IF YOU HAVE ANY QUESTIONS OR ARE

MISSING A PART, PLEASE VISIT:

www.creativecedardesigns.com

Customer Service

1-888-363-4967

custservice@creativecedardesigns.com

Parts Indentification:

(8) "A" Panels

(12) "B" Panels

(4) "C" Panels

(4) "D" Panels

(30) 1-1/2'' Screws

(1) Weed Suppressant Lining - Ground Cover

(1) Polyethelene Top-Cover

Tools Required:

Phillips Screwdriver

STEP 1:

Slot four “B” panels into four “A” panels

by slideing cut-outs into on another (Detail 1)

and push down to secure firmly.

STEP 2:

Continue building sides of sand pit using

the eight “B” panels as shown.

STEP 3:

To complete the sides of the sandpit, slot the

last four “A” panels into the four “B” panels

as shown.

STEP 4:

Attach four support plate “D” with 1-1/2”

Screws, placed close to the middle of each

section as shown.

D D

PAGE 1
Octagonal Sand Pit Assembly Instructions MODEL #7120 Parts Indentification: (8) "A" Panels STEP 1: STEP 2: STEP 3: Slot four “B” panels into four “A” panels by slideing cut-outs into on another (Detail 1) and push down to secure firmly. Continue building sides of sand pit using the eight “B” panels as shown. To complete the sides of the sandpit, slot the last four “A” panels into the four “B” panels as shown.
PAGE 2
Octagonal Sand Pit Assembly Instructions MODEL #7120 STEP 5: STEP 6: Screw seats “C” to sides through pre-drilled holes (Detail 2) using four 1-1/2” Screws per seat. Place sandpit on top of ground-cover on level ground. Trim excess to fit sandpit. Fill with sand. Keep your sandpit safe for the children 1. Always cover the sandpit when not in use, to prevent unwanted animals from playing in the sand. 2. Before covering your sandpit, place a large object in the center of the sand to prop up the cover.